That watch you ordered — that cool, all-steel number — has finally arrived, after days of waiting. You take it out out of the box, remove the stickers and try it on. And unless you have Hulk-sized wrist, what you find is that the bracelet is a few links too big. You have two courses of action: you can take it to a jeweler or repair shop and spend something to the tune of $20 to get it professionally sized, or you can take matters into your own hands.
Fortunately, most watch bracelets come with a pretty simple “cotter pin” system made up of a metal pin within a hole, which holds the links together. That pin is, in some watches, paired with two small metal tubes called “ferrules” that hold it in place at both ends of the link. The pins and ferrules can be removed, either with affordable tools found online, or with whatever you’ve got in your junk drawer. But it’s still a frustrating task that requires finesse and calm. A slip of the wrist could scratch or dent the bracelet. If you put it all back together improperly, your watch could fall off your wrist.
“I’ve seen some horror stories of people trying to do it on their own,” said Steve Kivel of New York’s Central Watch repair shop. “Some are easy, and some can be very difficult, to the point where someone comes into our place, it takes 20 minutes because we have to replace something or change something that got bent while [the customer was] trying to change it.” Kivel recommends taking the watch to a shop if you want it done perfectly; but, for those planning on doing it at home, he shared some tricks and tips on how to remove watch links the right way.
See How Many Links You Need to Remove
Nothing in this process will be more frustrating than going through all this trouble only to find you’ve removed too many links. Try on your watch with all the links in on the bracelet. Position it to where you’d like to wear it on your wrist, then gather up the slack and count out how many excess links there are. Also keep in mind the placement of the clasp. Ideally, it should be centered on the bracelet, and you should be taking out an equal amount of links on both sides of the clasp to keep it that way. But, as Kivel notes, on some low-end and used watches, one side of the bracelet may be longer than the other. If this is the case, make sure you’re removing enough links from each side so that the clasp is dead center.
Prepare Your Workspace
“You want to work on a flat surface,” says Kivel. “If a piece falls out and you’re not expecting it, they’ll easily roll and end up on the floor.” Just to be extra cautious, Kivel also recommends keeping something at the edge of the table to stop any rogue pins or ferrules from falling off. Additionally, a mat or soft surface should be used to protect your metal watch from scratching your tabletop. As a final note, Kivel recommends keeping an uncluttered and calm atmosphere. “As watchmakers, we’re in a clean, quiet and calm environment every day. At home, be in a quiet environment and don’t be distracted by the phone, or texts, or anything else like that.”
Acquire (or Make) Tools
For removing cotter pins, you’ll need a push-pin tool, a small ball-peen hammer and a watch-bracelet holder — most of which you can get in a preassembled kit. But if you’re in a hurry, or you don’t want to spend the money, you can easily find and MacGyver up your own tools at home. For the bracelet holder, Kivel advises using a piece of hard foam and cutting a groove into it. This way, when you hammer out the pin inside the link, it will stick into the foam and have a place to go. For the push-pin tool, an appropriately sized nail or tack can be used, but Kivel suggests filing down the point into a flat surface to avoid marking up the bracelet.
